MOSFET kit Rambo Mini

NOTE: This MOSFET is for DC only. It may burn when running recent Prusa firmware which powers the heat bed in PWM. 

The kit contains:

• 1 MOSFET
• 1 connection cable with plug
• 4 WAGO terminals
• 6 black (color may differ) ferrules insulated
• 2 white (color may differ) ferrules insulated

Helps your 3D printer equipped with the controller board (capable of max 15A) to become more powerful. Add this module to the board to lead the maximum current up to 25A.

If you intend to use a heatbed with a 12V power supply in your 3D printer, this module is recommended. A different module might cause cause excessive current which may burn the connectors on the controller board. According to the thermal power of the bed, please choose the appropriate power supply, with sufficient margin. If it is large power heated, we suggest 24V power supply, under the same power requirements, current is less than 12A.

• Dimensions: 60*50mm 
• Net Weight: 25g 
• Color:Black 
• Max Current: 25A (Enhance heat dissipation) 

WAGO terminals:

Solid, stranded and fine-stranded conductors with different cross sections can be connected. In a Caribou it's used in the Rambo-box.

• Cross section: 28 - 12 AWG (stranded and solid)
• Strip length: 9 - 10 mm / 0.37 in
• Rated Voltage: 400V
• Rated Current: 32A
• Rated power: 7KW