Prusa Mini Extruder Upgrade To IFS™

Filament Sensor
It will change the front housing of the previous version of the Prusa Mini extruder so the new filament sensor for Prusa Mini/+ may be mounted inside.

Upgrade Your Prusa Mini or Mini+
Upgrade your Prusa Mini/+ with a Bondtech Dual Drive extruder designed to seamlessly fit the original setup.

Filament Sensor Compatible
The Bondtech Internal Filament Sensor Extruder for Prusa Mini may embed the new Prusa filament sensor for Mini or Mini+ on its housing.
The extruder may be used with or without the filament sensor.

Hardened Drive Gears
Allows to use abrasive materials that would wear out the gears of your original feeder otherwise.

Adjustable tension
The thumbscrew tensioner allows the user to fine-tune the pressure exerted by the drive gears onto the filament. This gives you the power to adjust according to your preferences and to optimize for the type of material you are using.

Quick-Release
To be able to do material changes in a snap, simply activate the Quick-Release lever to release the tension and pull the material to be changed out of the extruder, keep it activated and insert the new material.

More choice of materials
The hardened steel Dual Drive gears allow you to work with common and abrasive materials.

Included in this Kit

• 1x 10076-3 Front Housing (PA12)
• 1x Bondtech IFS extruder for Prusa Mini
• 1x 10076-4 IFS Magnet Holder (PA12)
• 1x 10076-5 IFS Lever (PA12)

Not included in this Kit

• Prusa Filament Sensor
• Filament Sensor Magnets
• Filament Sensor Steel Sphere

 
Community Sourced Design
The original Bondtech extruder for Prusa Mini design was proposed to us by Olof Ogland This new IFS version was developed by Vecko Kojchevski on top of Olof’s work. It’s based on the thoroughly tested BMG (Bondtech Mini Geared) and adjusted to the Prusa Mini original design.