Bondtech Heat-Break Kit For Prusa Mini

Bondtech Heat-Break Kit For Prusa Mini

on backorder
€16.75

To solve Heat-creep

This Stainless Steel heat-break made by Bondtech for the Prusa Mini addresses and solves the heat-creep issues revealed during the extensive testing we performed on the Prusa Mini. The adjusted length of the PTFE tube also prevents clogs to form between tube and heat-break

 

 

Included in this kit:

  • 1x 32×5.48 mm stainless steel heat-break
  • 1x 35.3 mm 2/4 chamfered PTFE tube

 
Recommendation

We recommend to use thermal paste to properly fit the Bondtech heat-break in the Mini’s heat-sink.

Notes on twisting the heat-break

To address the heat creep issue the design features a narrower section with thinner walls. When removing the heater block or changing nozzles, caution is required.

Before removing the heater block from the heat-break (or vice versa), heat-up the nozzle, hold the heater block and release some tightening pressure from the nozzle. Let the whole group cool down. After, you can simply unscrew the heat-break from the heater block.
 

To remove or replace a nozzle, never forget to secure the heater block before twisting the nozzle.

 

Community Sourced Design

This heat-break design was proposed to by Olof Ogland and Bondtech adjusted it to its final form during the deep testing performed on the Prusa Mini. There is a new X-Carriage design that will properly route the new IR filament sensor cable.

Customers who bought this product also bought:

Product added to wishlist