This product has reached end-of-life and will be replaced by Prusa Mini IFS.
Bondtech high-resolution extruder upgrade for the Prusa Mini enabled with Dual Drive Technology.
Upgrade Your Prusa Mini
Upgrade your Prusa Mini with a Bondtech Dual Drive extruder designed to seamlessly fit the original setup.
Hardened Drive Gears
Allows to use abrasive materials that would wear out the gears of your original feeder otherwise.
Print Faster Or With Higher Quality
This bowden extruder will allow your 3D printer to print faster or to achieve even better surface quality.
The thumbscrew tensioner allows the user to fine-tune the pressure exerted by the drive gears onto the filament. This gives you the power to adjust according to your preferences and to optimize for the type of material you are using.
To be able to do material changes in a snap, simply activate the Quick-Release lever to release the tension and pull the material to be changed out of the extruder, keep it activated and insert the new material.
More choice of materials
The hardened steel Dual Drive gears allow you to work with common and abrasive materials.
Included in this Kit:
- 1x Bondtech extruder for Prusa Mini
- 3x Black nylon zip-ties
- 4x M3x35 black oxide steel screws
- 1x M3x12 black oxide steel screw
- 1x Brass motor gear
- 1x Thumb Screw assembly
Community Sourced Design
This heat-break design was proposed to us by Olof Ogland and we adjusted it to its final form during the deep testing we performed on the Prusa Mini. There is a new X-Carriage design that will properly route the new IR filament sensor cable.