SLS X-Carriage kit for Prusa i3 MK3S
SLS X-Carriage kit for Prusa i3 MK3S
SLS X-Carriage kit for Prusa i3 MK3S
SLS X-Carriage kit for Prusa i3 MK3S

SLS X-Carriage kit for Prusa i3 MK3S

on backorder
€39.50

High Temperature X-Carriage

An X-Carriage kit is required to install our Bondtech Upgrade Kit for Prusa i3 MK3S.
This SLS version is for users that work with enclosed chambers and heat the air inside above 60°C
 

 

Included in this product:

  • SLS X-Carriage Front
  • SLS X-Carriage Rear
  • 5x M3x10 Screws
  • 5x M3 square nut
  • 1x M3 nut


3D Printed In PA12

The 3D printed parts of this kit are printed using SLS technology with White PA12, sandblasted and dyed in Black.

Working Temperature Limits

Bear in mind the working temperature limit of this product does not extend to the Upgrade Kit itself. If you use this X-Carriage Kit and any Bondtech Upgrade Kit for Prusa inside a closed chamber, it will have the following set of working temperature limits:

  • Due to the sensor plastic parts made of HT PLA > up to 60°C (90-100°C when parts are annealed);
  • Due to the stepper motor > up to 80°C.
  • The PA12 parts themselves can withstand up to 100°C.Note: If you print inside an enclosed chamber use the SLS version instead, to allow heating the air inside above 60°C.

You might also like

Customers who bought this product also bought:

Product added to wishlist